cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Need to share some code when posting a question or reply? Make sure to use the "Insert code sample" menu option. Learn more! X

Mold opening simulation with slider in EMX 8.0

shaanmech
1-Newbie

Mold opening simulation with slider in EMX 8.0

Can anyone explain how to perform interference check for slider lifter during mold opening or how to perform mold opening simulation with slider movement?? please give me ur suggestion.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

The slider set used in the demo is HASCO single Locking. I changed angle pin length to 90 to increase the pull out distance. The assembly file is available with the link below. It was created in Creo 3.0/EMX 9.0.

https://onedrive.live.com/?id=B7F645E1024EF076!373&cid=B7F645E1024EF076&group=0

View solution in original post

10 REPLIES 10

There is no additional configuration for slider. When performing mold opening simulation, slider sets will be classified into a SLIDER group automatically. 

Use proper values for Total Opening and Step Width. Slider will move along the right direction (X) during mold opening.

Video Link : 6166

Thank you for your reply sir , but the slider sets are not classified into SLIDER GROUP automatically for me please help me ..... mold simo.PNGmold simu.PNG

Did you use the OOTB slider sets? EMX is not able to recognize the slider components if some specific datums are missing. If custom slider sets are required, the easiest way is to duplicate an existing one and modify it to fit your requirements.

I am using existing slider sets, but I can't get slider movement. What is OOTB slider sets? I can't get it. Can you send me the assembly file that you used to explain me in the video so that I can get some idea? Thank you for your response.

The slider set used in the demo is HASCO single Locking. I changed angle pin length to 90 to increase the pull out distance. The assembly file is available with the link below. It was created in Creo 3.0/EMX 9.0.

https://onedrive.live.com/?id=B7F645E1024EF076!373&cid=B7F645E1024EF076&group=0

Thank you very much sir, I tried a new one with HASCO slider sets it worked well..........

Sir is there any option to add a new supplier to in the supplier list of EMX, If so how can we add a new supplier ?? Or is there any option to create a supplier to our requirements?  Please help me sir....

Can you initiate a discussion for this topic? I would reply to the post then.

Ok Sir. I m waiting for u in the new discussion sir.....

tschneyer
6-Contributor
(To:shaanmech)

Ryan Kelley‌: Can you please move this entry to the group Expert Moldbase Extension - EMX

Kind Regards
Thomas Schneyer
B&W Software GmbH
Top Tags