cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Extrude & Arc

rubenvillarreal
13-Aquamarine

Extrude & Arc

Hello,

I tried to extrude this arc, what happens is that it becomes in a really poor arc with no smoothness at all.

What should I do?

Thanks!

1.png2.png3.png

1 ACCEPTED SOLUTION

Accepted Solutions

Ruben,

click File > Options (if you use Creo Parametric 2.0) and experiment with below show settings.

options1.png

options2.png

Martin Hanak


Martin Hanák

View solution in original post

9 REPLIES 9

I think you should change the accuracy in the "model properties"

rubenvillarreal
13-Aquamarine
(To:ashi)

Alex, how should I do that? I changed but nothing happens, the arc remains with the same imperfection.

Ruben,

click File > Options (if you use Creo Parametric 2.0) and experiment with below show settings.

options1.png

options2.png

Martin Hanak


Martin Hanák

Martin, I set the edge display quality to very high, even with that the arc is still appearing with little "pixels", I render it with maximum accuracy and that doesn't solve my problem.  I know that this is the correct procedure and probably the correct answer, I'm just wondering if there is another procedure to solve this.  Thanks!

Ruben,

you can also test adding the following option at the end of config.pro file temporarily. This way you will turn OPENGL graphics off.

graphics win32_gdi

Martin Hanak


Martin Hanák

Ruben,

Does the information from Martin answer your question? You may mark reply to post as correct answer.

Kind of. Tomorrow I will set that as the correct answer if there are no other solutions. 

You only mention that you set your edge display to "very high"

Try setting your shade quality to "10" too.

ron

I didn't understand how to add the config.pro file that Martin said. So, this was the result with the edge display set to very_high and the shade display quality set to 50 (highest value possible).

2.png

1.png

Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags