https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/756688#M12373 <P>This solved me from error by using contat Interferances</P><P>&nbsp;</P> Thu, 04 Nov 2021 11:28:29 GMT RN_10004064 2021-11-04T11:28:29Z https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/755113#M12352 <P>Hello,</P><P>&nbsp;</P><P>I had created profiles using the Bosch Profiles in creo 7.0 and then i am simulating it in creo simulate 7.0 but i found some errors. could anyone please help me.</P> Wed, 27 Oct 2021 11:35:57 GMT https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/755113#M12352 RN_10004064 2021-10-27T11:35:57Z https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/755218#M12355 <P>Here's the article -&nbsp;"<STRONG>Mesh creation in Creo Simulate fails with message: "AutoGEM may not be able to complete because the volume boundaries either intersect or overlap near the highlighted surfaces"</STRONG> ":&nbsp;<A href="https://www.ptc.com/en/support/article/CS115533" target="_blank">https://www.ptc.com/en/support/article/CS115533</A></P> Wed, 27 Oct 2021 17:34:52 GMT https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/755218#M12355 VladimirN 2021-10-27T17:34:52Z https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/756688#M12373 <P>This solved me from error by using contat Interferances</P><P>&nbsp;</P> Thu, 04 Nov 2021 11:28:29 GMT https://www.ptcusercommunity.com/t5/PTC-Education-Forum/CREO-Simulate-7-0/m-p/756688#M12373 RN_10004064 2021-11-04T11:28:29Z