topic Fwd: Drawings will not open in Pro/E after replication server disconnected. in Windchill

topic Fwd: Drawings will not open in Pro/E after replication server disconnected. in Windchill https://www.ptcusercommunity.com/t5/Windchill/Fwd-Drawings-will-not-open-in-Pro-E-after-replication-server/m-p/301403#M35372 <HTML><HEAD></HEAD><BODY>This happened because you still have some of your data left in your Hungary RFS which has not yet synced to your master site. You can bring the server up and perform a sysforce sync from JMX console and pull the contents to master, 1.Bring up your Hungary replica to network, it is not dependent on the geographical location of server, but make *sure the server FQDN is retained* 2.Launch JMX by running the windchill *wt.util.jmx.SEJconsole* from Windchill Shell 3. Access the CacheVautlSynchronizer *Mbean *in JConsole under *Mbeans tab >com.ptc>monitors *(WHC- Link<<A href="http://www.ptc.com/cs/help/windchill_hc/wc100_hc/index.jspx?id=filevaultChp_FileSynchron&action=show'%20style=" target="_blank">">http://www.ptc.com/cs/help/windchill_hc/wc100_hc/index.jspx?id=filevaultChp_FileSynchron&action=show></A> ) 4. Perform the 'SiteForceSync' operation for the Remote File Server. 5. Use the 'siteGetSynchHistory' operation to check the results to make sure that the task completed and that there were no errors. 6: Repeat steps 4 and 5 until there is no more data to move 7. verify there are no cached items left in replica, by running the below query *select count(*) from masteredonreplicaitem mori, replicafolder rf, replicavault rv, site si where mori.ida3a4 = rf.ida2a2 and rf.ida3a5=rv.ida2a2 and rv.ida3a5=si.ida2a2 and si.name='<site>';* 8.Decommission your replica, PTC CS:- <A href="https://www.ptc.com/appserver/cs/view/solution.jsp?n=CS53215," style=">https://www.ptc.com/appserver/cs/view/solution.jsp?n=CS53215,</a> *Warm Regards, BINESH Consultant - Windchill Barry Wehmiller International Resources * </body>" target="_blank"></A></BODY></HTML> Wed, 02 May 2018 14:37:33 GMT BineshKumar1 2018-05-02T14:37:33Z Fwd: Drawings will not open in Pro/E after replication server disconnected. https://www.ptcusercommunity.com/t5/Windchill/Fwd-Drawings-will-not-open-in-Pro-E-after-replication-server/m-p/301403#M35372 This happened because you still have some of your data left in your HungaryRFS which has not yet synced to your master site. You can bring the serverup and perform a sysforce sync from JMX console and pull the contents tomaster,1.Bring up your Hungary replica to network, it is not Wed, 02 May 2018 14:37:33 GMT https://www.ptcusercommunity.com/t5/Windchill/Fwd-Drawings-will-not-open-in-Pro-E-after-replication-server/m-p/301403#M35372 BineshKumar1 2018-05-02T14:37:33Z