topic Re: Creo Warning Messages - Config.pro options? in Analysis

Creo Warning Messages - Config.pro options?

GregFrankland — Fri, 04 May 2018 20:39:59 GMT

Hello all, I tried to do some search for this, but was unable to find it on my own. Maybe someone out there has the answer. We are currently running Creo 1.0 M030. I like the software, but there are two warning messages that pop up that are a little annoying and I am wondering if

Re: Creo Warning Messages - Config.pro options?

SteveMeyers — Fri, 09 Nov 2012 20:31:34 GMT

Gregory,

This tutorial on Learning Exchange will answer you question about "warn1". There is a configuration setting that tells Creo to switch from adding materail to removing materail based on the direction of the extrude. Watch this for the full explanation:

http://learningexchange.ptc.com/tutorial/2876/smart-extrusions

Cheers

Re: Creo Warning Messages - Config.pro options?

GregFrankland — Thu, 06 Dec 2012 14:25:27 GMT

Thanks for the reply, and nice tutorial!

I knew about the automatically switching from protrusion to cut. I was wondering if there is a way to turn off these warning messages that pop up. I can click on the check box that says don't show in the future, but it always comes up the next time I launch the software.

-Greg

Re: Creo Warning Messages - Config.pro options?

jsarkar — Thu, 06 Dec 2012 16:59:33 GMT

for warning 2> if u check the box of do not show future option, is that not working?

Re: Creo Warning Messages - Config.pro options?

GregFrankland — Tue, 12 Mar 2013 14:53:45 GMT

Works while in session, but launching new session will cause them to appear again. I was hoping for a more permanent solution.

-Greg

Re: Creo Warning Messages - Config.pro options?

bp — Tue, 07 May 2013 14:22:03 GMT

Has anyone already found a config. option to keep these message boxes from popping up?

Re: Creo Warning Messages - Config.pro options?

BJP — Wed, 05 Dec 2018 08:16:50 GMT

We just move to Creo5 and still no option for this?!