topic Re: Does Production Machining give .tap and g-code functionality? in Manufacturing (CAM)

Does Production Machining give .tap and g-code functionality?

dmayfield — Sun, 13 Dec 2020 18:36:42 GMT

Will the production machining option in Creo give me the ability to post process my models in manufacturing mode to a .tap file. Will it also post process to g-code and does it come with the basic drivers to post to g-code?

Re: Does Production Machining give .tap and g-code functionality?

SteveLucas — Thu, 08 Dec 2016 20:51:39 GMT

Dustin,

Yes the production machining has the ability to post process files to G Code using G Post from Austin NC. All the manufacturing modules have the ability except for expert machinist as I found out a while ago.

There is a large assortment of pre built posts in the support portal that you can use or build your own using them as starting points.

Steve L.

Re: Does Production Machining give .tap and g-code functionality?

dmayfield — Thu, 08 Dec 2016 20:56:47 GMT

The large assortment of pre-built posts are located here: http://support.ptc.com/cs/cs_27/howto/ncgp4905/ncgp4905.htm correct?

Thanks!

Re: Does Production Machining give .tap and g-code functionality?

SteveLucas — Thu, 08 Dec 2016 20:59:19 GMT

Those are the ones. can't you find what you are looking for?

Re: Does Production Machining give .tap and g-code functionality?

BillChapman — Thu, 08 Dec 2016 21:05:47 GMT

You can also check out the one that Austin N.C. has, this may be more up to date.

Austin N.C. - Mill Postprocessor Library

Re: Does Production Machining give .tap and g-code functionality?

dmayfield — Thu, 08 Dec 2016 21:12:39 GMT

Those are all fine, was just checking if that was the full library! Thanks so much