topic Re: Drawing: spline render error in 3D Part & Assembly Design https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414554#M109585 <HTML><HEAD></HEAD><BODY><P>Nudge. Any ideas, please? I've tried changing the angle of the view by 5º but it does not solve it.</P></BODY></HTML> Tue, 16 Jun 2015 10:24:14 GMT acoates 2015-06-16T10:24:14Z Drawing: spline render error https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414553#M109584 Hello,Has anybody seen the following before, please? I have a harness that renders well in the part and assembly but in the assembly drawing the splines cannot be handled. The image on the left shows the incorrect render in the drawing; the image in the middle shows the harness being Sun, 13 Dec 2020 14:25:27 GMT https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414553#M109584 acoates 2020-12-13T14:25:27Z Re: Drawing: spline render error https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414554#M109585 <HTML><HEAD></HEAD><BODY><P>Nudge. Any ideas, please? I've tried changing the angle of the view by 5º but it does not solve it.</P></BODY></HTML> Tue, 16 Jun 2015 10:24:14 GMT https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414554#M109585 acoates 2015-06-16T10:24:14Z Re: Drawing: spline render error https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414555#M109586 <HTML><HEAD></HEAD><BODY><P>No hidden mode in assembly drawings has difficulty with interferences.&nbsp; Can you run an interference check or try suppressing some of the models?&nbsp; (These look like surfaces, so not sure if this will apply.)</P></BODY></HTML> Tue, 16 Jun 2015 13:13:09 GMT https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Drawing-spline-render-error/m-p/414555#M109586 TomU 2015-06-16T13:13:09Z