topic Re: Best practices for importing and exporting 3D models in 3D Part & Assembly Design

Best practices for importing and exporting 3D models

Jonathan_Felipe — Wed, 22 Mar 2023 13:56:39 GMT

Working with imports and exports of 3D models, I believe that it is not constant mathematics since it will depend a lot on the model and the source software, but I would argue that it is necessary to have a base of best practices for this
Does anyone have any kind of document on best practices for importing and exporting 3D models in Creo?

Re: Best practices for importing and exporting 3D models

VladimirN — Thu, 23 Mar 2023 10:17:51 GMT

From "Help Center" - "About Importing and Exporting STEP Associative Drafting and 3D Data": https://support.ptc.com/help/creo/creo_pma/r9.0/usascii/index.html#page/data_exchange/interface/About_Importing_and_Exporting_Step_Associative_D.html
"3D Import Export": https://www.ptc.com/en/support/creo-landing/creo-landing-main/configure-creo-setup/3d-import-export

Re: Best practices for importing and exporting 3D models

Jonathan_Felipe — Thu, 23 Mar 2023 10:57:28 GMT

Thank you for your help
great content

Re: Best practices for importing and exporting 3D models

VladimirN — Fri, 24 Mar 2023 09:06:00 GMT

You're welcome.