topic Re: Snap problem in 3D Part & Assembly Design

Snap problem

Dome_dv — Thu, 30 May 2024 12:31:41 GMT

Hi, suddenly my creo started giving problems with the snap no longer taking references, I tried to load the config.pro file that I had exported previously but it still doesn't work. if I open a new project the snap works correctly

Re: Snap problem

tbraxton — Thu, 30 May 2024 12:46:12 GMT

Check these settings: To Set the Snapping Settings (ptc.com)

Re: Snap problem

Dome_dv — Thu, 30 May 2024 15:21:01 GMT

I've already tried but it doesn't change

Re: Snap problem

StephenW — Thu, 30 May 2024 15:24:08 GMT

If it is working normally in a new part, then the setting is correct. There is something about your part that is not allowing references.

There used to be an issue with mirror, where when you tried to add a reference, it would give you an error "additional references not allowed", not sure if this is still the case.

Re: Snap problem

Dome_dv — Thu, 30 May 2024 16:00:26 GMT

Fixed by turning off perspective view.