topic Re: Incorrect displaying thick cable on drawing view in 3D Part & Assembly Design

Incorrect displaying thick cable on drawing view

MK_10622412 — Thu, 20 Jun 2024 10:41:31 GMT

I have the huge assembly. One of the drawing view have local section.

The option "remove_cosms_from_xsecs" - set as "trim". In this case the section is shown correctly, but some cables are not visible or partially visible. When I change option "remove_cosms_from_xsecs" to "total", then all cables become visible, but section looks strange. Please see attached picture: there are shown displaying with different settings. Maybe somebody knows the secret trick how to make all thick cables visible and at the same time so that the local section is displayed correctly?

I use Creo 9.

Re: Incorrect displaying thick cable on drawing view

MK_10622412 — Fri, 21 Jun 2024 07:50:57 GMT

One more addition: if section Full and "remove_cosms_from_xsecs" - set as "total" view looks good. When I change type of section to Local, then geometry lines in section area fails and looks as on 2nd example on picture.

Re: Incorrect displaying thick cable on drawing view

vnamboodheri — Fri, 28 Jun 2024 05:41:25 GMT

Hi @MK_10622412,

Thank you for your question.

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Regards,

Vivek N

Community Moderation Team.