topic Re: Creo 8 / flat harness / create a flat harness with several independent wires in 3D Part & Assembly Design

Creo 8 / flat harness / create a flat harness with several independent wires

TM_10264935 — Mon, 21 Oct 2024 19:44:13 GMT

Hello, is it possible to create a flat harness with wires that are not in direct contact?

As in picture 1, it is composed of separate wire. the problem is when I decide a start point, I can not go and look for another point on a non-attached wire.

I would like to know if it is possible to do everything in one flat harness or if it is necessary to separate each wire that does not touch into different harnesses?

Re: Creo 8 / flat harness / create a flat harness with several independent wires

anursingh — Mon, 28 Oct 2024 20:47:46 GMT

Hi @TM_10264935,

Thank you for your question.

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Also, feel free to add any additional information you think might be relevant. It sometimes helps to have screenshots to better understand what you are trying to do.

Regards,

Anurag