topic Quantity split clircle BOM balloon the default in 3D Part & Assembly Design

Quantity split clircle BOM balloon the default

AJ_TROGLIO — Wed, 20 Nov 2024 16:00:26 GMT

We have decided to standardize on the quantity split balloon as our standard callout on engineering assembly drawings. However, the default balloon when placing is the simple circle balloon. To switch we need to change the table properties every time.

Anyway to make quantity split balloon the standard when dropping them into a drawing?

Re: Quantity split clircle BOM balloon the default

BenLoosli — Wed, 20 Nov 2024 16:17:50 GMT

In your .dtl file assigned to your drawing template or set in your drawing template the following:

default_bom_balloon_type quantity_split_circle

Re: Quantity split clircle BOM balloon the default

AJ_TROGLIO — Wed, 20 Nov 2024 16:23:10 GMT

Awesome, Thanks Ben