topic Hole Note Refinement in 3D Part & Assembly Design

Hole Note Refinement

wbottis — Fri, 18 Apr 2025 16:58:32 GMT

Hi Folks,

Using Creo 7.0.8.0

In the 'Shape' sub-tab of the 'hole' modeling feature ribbon, I recall the graphic used to show the tap-drill depth. I don't see this anymore. Nonetheless, is there a way to add drill depth to the note callout properly? This is omitted and only tap-depth is shown. Thank you.

Re: Hole Note Refinement

BenLoosli — Fri, 18 Apr 2025 17:57:12 GMT

Creo 9.0.9.0 shows what you want for the note, but not graphically.

Re: Hole Note Refinement

pausob — Sun, 20 Apr 2025 20:43:38 GMT

At some point, the GUI changed and now the tap drill depth is specified elsewhere:

It seems the reason your note doesn't show it is because you are using a custom hole table (UNC-2B_RTN ?) that has a callout definitions that do not display the dap drill depth...

Re: Hole Note Refinement

anursingh — Mon, 28 Apr 2025 08:01:09 GMT

Hi @wbottis,

I wanted to see if you got the help you needed.

If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation.

Thanks,
Anurag