topic Re: Cutting line does not comply with ISO standards (ISO 128-2, ISO 128-3) in 3D Part & Assembly Design

Cutting line does not comply with ISO standards (ISO 128-2, ISO 128-3)

AS_10638234 — Mon, 12 May 2025 06:05:09 GMT

Hello everyone,

The settings for the cutting planes do not correspond to the ISO standards (ISO 128-2:2022, ISO 128-3:2022).

- The end segments should be marked with a long-dashed dotted wide line.

- The end segment must be exactly long-dashed-long

- The arrow must be centred on the last long segment.

I can't find these settings anywhere.

Is there a solution? We all want a digital MBD world, but at the moment we still need 2D drawings, so a standardised representation is absolutely vital.

Re: Cutting line does not comply with ISO standards (ISO 128-2, ISO 128-3)

MartinHanak — Mon, 12 May 2025 06:08:49 GMT

Hi,

please open Case at PTC Support and ask them the same question.

Re: Cutting line does not comply with ISO standards (ISO 128-2, ISO 128-3)

AS_10638234 — Tue, 20 May 2025 05:59:44 GMT

Thanks for the tip, I am still waiting for a response to my case at PTC. Once I have received this, I will post an update.

Re: Cutting line does not comply with ISO standards (ISO 128-2, ISO 128-3)

romainr — Thu, 10 Jul 2025 15:37:39 GMT

Hi, did you have any update on this from PTC ?

We are currently checking if Creo Parametric can fully comply with ISO 128-2 and 128-3.

Many thanks.

Re: Cutting line does not comply with ISO standards (ISO 128-2, ISO 128-3)

AS_10638234 — Mon, 14 Jul 2025 05:15:17 GMT

Hi everyone,

my case was closed by the support without a solution.