topic Re: Hole table auto-updates with wrong parameters in 3D Part & Assembly Design

Hole table auto-updates with wrong parameters

MH_10735227 — Thu, 09 Oct 2025 06:33:16 GMT

Hi!

I have a part with different holes. In my 2D drawing I am using the default hole table from Creo (v8.09). It shows for example M2.5x.45 ISO in the cell but when I look at the hole annotation, it shows

M2.5x.45 ISO - H

2.7 DRILL ( 2.700 ) THRU

So why it doesn't show this in the hole table?

I tried to change in the table the definition of the cell to include these information. Then I go back to the part and back again to the drawing and the cell content is back to what it was before.

Why is that?

Also I have a clearance hole on the part, but in the hole table it shows M2.5x.45 ISO. This is wrong.

Re: Hole table auto-updates with wrong parameters

vnamboodheri — Thu, 16 Oct 2025 07:11:57 GMT

Hi @MH_10735227,

Thank you for your question.

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.
Also, feel free to add any additional information you think might be relevant. It sometimes helps to have screenshots to better understand what you are trying to do.

Best Regards,

Vivek N
Community Moderation Team

Re: Hole table auto-updates with wrong parameters

Srinivasan-Iyer — Wed, 12 Nov 2025 04:10:06 GMT

To answer your question, please state the purpose for a Hole Table. If we understand the purpose, we can perhaps suggest a better way of doing it.

e.g. MBD