topic Tolerance overlap issue in 3D Part & Assembly Design

Tolerance overlap issue

cchin — Sun, 13 Dec 2020 02:19:10 GMT

Tolerance overlapping when add tolerance dimension (plus/minus) in the drawing part. How to fix it? Thanks.I attached with an example of issue.

Re: Tolerance overlap issue

sgupta-2 — Thu, 26 Feb 2015 04:18:37 GMT

Hello Chin,

Height and width of the tolerance text are controlle by the following two drawing setup file options.

TOL_TEXT_HEIGHT_FACTOR

TOL_TEXT_WIDTH_FACTOR

Change the value as per your requirement.

Re: Tolerance overlap issue

cchin — Mon, 02 Mar 2015 05:29:37 GMT

I did following set up to TOL_TEXT_HEIGHT_FACTOR and TOL_TEXT_WIDTH_FACTOR .

The text height and width factor change on a line. but, the tolerance plus and minus (2 line) still overlap.

please advise. Thanks

Chin

Re: Tolerance overlap issue

TomD.inPDX — Mon, 02 Mar 2015 07:37:45 GMT

If this is Creo 3 and you have maintenance, please submit a support case so this can resolved if it is indeed a bug.

You can also see if this is a configuration problem by opening Creo as a default install. Then changing the settings one at a time to get to what your standard is.

I do not use this style dimensioning. Normally I just sneak up on these settings one at a time. It makes sense to start with a clean slate.

Re: Tolerance overlap issue

sgupta-2 — Mon, 02 Mar 2015 07:47:31 GMT

set text_height 2.5

set TOL_TEXT_HEIGHT_FACTOR 1 for ANSI and 0.6 for ISO

Re: Tolerance overlap issue

Mahesh_Sharma — Tue, 03 Mar 2015 00:34:58 GMT

For a quick trial set drawing option update_drawing as all and update the drawing. (Open drawing, File > drawing options > Add update_drawing under option name and all under value > Add/Change > Close)

Re: Tolerance overlap issue

tthangadurai — Tue, 03 Mar 2015 08:43:31 GMT

Hi Chin chin,

Still you do not find any solutions please upload the model & drawing.

Regards

Thangavijay T