topic Re: Creo Drawing....Cleanup Dimension Issues for diametrical dimensions in 3D Part & Assembly Design

Creo Drawing....Cleanup Dimension Issues for diametrical dimensions

mbalasubramaniy — Sun, 13 Dec 2020 02:24:44 GMT

Hi guysI have part with a single revolve feature....where the revolve diameter is so large compared to the sectional dimensionFor example lets say revolve diameter as 900 mm and section is of 40mm X 20 mm.....and revolve angle is 25 degree symmetrical.So when i'm creating a drawing

Re: Creo Drawing....Cleanup Dimension Issues for diametrical dimensions

TomD.inPDX — Thu, 05 Feb 2015 07:18:21 GMT

I think an image for clarification is in order here.

Re: Creo Drawing....Cleanup Dimension Issues for diametrical dimensions

mbalasubramaniy — Fri, 06 Feb 2015 05:56:29 GMT

here's the image....

The diametrical dimension needs to be snap at a certain angle or any from the parts edge.....need help here

Re: Creo Drawing....Cleanup Dimension Issues for diametrical dimensions

TomD.inPDX — Fri, 06 Feb 2015 06:13:49 GMT

I wish a lot of features in detailing were more intuitive.

Typically, this dimension would be specified as a Z-Radius so you can show a centerline mark.

Even that has a bug in that it doesn't draw the tail correctly and draws an arc on the opposite side.

If you have active maintenance, feel free to create an idea for consideration.

edit: I reported the Z-Radius issues... below is Creo 3 ... Creo 2 also adds an extension line to the opposite side of the part.

Re: Creo Drawing....Cleanup Dimension Issues for diametrical dimensions

mbalasubramaniy — Tue, 07 Apr 2015 05:59:37 GMT

Thanks for your reply...i think i can accommodate that...