topic Re: Printer Lineweight in 3D Part & Assembly Design https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Printer-Lineweight/m-p/193001#M44770 <HTML><HEAD></HEAD><BODY><P>Hi Ted...</P><P></P><P>I'm not sure if the lineweights in Creo can still be manipulated with a table.pnt (pen table file) but here's one to try it with. Try pointing to this file in your printer setup and see if this corrects the problem. If so, I'll send you the entire guide I wrote on how to manipulate pen table files.</P><P></P><P>Thanks!</P><P>-Brian</P></BODY></HTML> Thu, 21 Jun 2012 22:59:42 GMT BrianMartin 2012-06-21T22:59:42Z Printer Lineweight https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Printer-Lineweight/m-p/193000#M44769 Hello Planet PTC,As a new user of Creo 1.0, I've run into an issue with the final printing that I have been unable to solve. Any member of my assembly that has been sectioned, the entire sectioned member and not just the cut face, and the border of all detail views are printing Sun, 13 Dec 2020 03:27:02 GMT https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Printer-Lineweight/m-p/193000#M44769 ptc-4482052 2020-12-13T03:27:02Z Re: Printer Lineweight https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Printer-Lineweight/m-p/193001#M44770 <HTML><HEAD></HEAD><BODY><P>Hi Ted...</P><P></P><P>I'm not sure if the lineweights in Creo can still be manipulated with a table.pnt (pen table file) but here's one to try it with. Try pointing to this file in your printer setup and see if this corrects the problem. If so, I'll send you the entire guide I wrote on how to manipulate pen table files.</P><P></P><P>Thanks!</P><P>-Brian</P></BODY></HTML> Thu, 21 Jun 2012 22:59:42 GMT https://www.ptcusercommunity.com/t5/3D-Part-Assembly-Design/Printer-Lineweight/m-p/193001#M44770 BrianMartin 2012-06-21T22:59:42Z