topic Re: Modeling a compression spring using relations in 3D Part & Assembly Design

Modeling a compression spring using relations

rgonzalez — Sun, 13 Dec 2020 09:55:04 GMT

The following links are to YouTube videos describing how to model flexible compression springs using relations:

Creo compression spring - Part 1 - YouTube

Creo compression spring - Part 2 - YouTube

Creo compression spring - Part 3 - YouTube

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

Re: Modeling a compression spring using relations

TomU — Thu, 27 Aug 2015 21:17:13 GMT

Richard Gonzalez‌, all of your video files have been removed from YouTube. Are you planning to repost them here in the community?

Re: Modeling a compression spring using relations

rgonzalez — Fri, 28 Aug 2015 13:36:41 GMT

Had an error in them. They are back up now. However, I can't seem to edit the post to give new addresses.

Re: Modeling a compression spring using relations

rgonzalez — Fri, 28 Aug 2015 13:58:41 GMT

Creo Flexible Compression Spring - Part 1 of 3 - YouTube

Creo Flexible Compression Spring - Part 2 of 3 - YouTube

Creo Flexible Compression Spring - Part 3 of 3 - YouTube

Re: Modeling a compression spring using relations

TomU — Fri, 28 Aug 2015 14:11:33 GMT

Yeah, that's one of the limitations of the forum. You can only edit a post or reply as long as no one has responded to it. Once they reply it locks forever!