Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi,
Need some help, I just installed Creo 1.0 Student edition I was using Wildfire 5.0. However now when I try and open assemblies created in Wildfire 5.0 the program either crashes or the assembly opens looking completely different from original assemblies. .PRT's seem to open OK, its just .ASM's that are causing problems. Any help is much appreciatted.
Thanks
Matt
Hello!
Try to fill the form "PTC Academic Support Request Form", here: