failure to plot

[Fred_Kohlhepp]

I see by your profile you're not new. I assume that you know enough to assign a point type to the trace for the single point.

Shown in 11, works in all.


Fred Kohlhepp
fkohlhepp@sikorsky.com

[Fred_Kohlhepp]

I see by your profile you're not new. I assume that you know enough to assign a point type to the trace for the single point.

Shown in 11, works in all.


Fred Kohlhepp
fkohlhepp@sikorsky.com

[rmix22-disabled]

On 3/23/2010 2:04:34 PM, dmg wrote:
>Here I am attempting to plot a
>line and a single point. I
>can't seem to get point to
>plot....done this many times

It seems this has to do with the reverse order on your ordinata-axis. It goes up from 15 to 12. If you change that running from 12 to 15 you see your point - at least half of it.

I think, this is a bug.

RMix

[RichardJ]

On 3/23/2010 3:04:50 PM, rmix22 wrote:

>It seems this has to do with the reverse
>order on your ordinata-axis. It goes up
>from 15 to 12. If you change that
>running from 12 to 15 you see your point
>- at least half of it.
>
>I think, this is a bug.

That is a known bug in MC14.

Richard