Ctrl Enter

[nkaplan]

In Mathcad 15 you can break an expression into two or more lines using Ctrl Enter. How do you do this in Prime 3.1?

@

[LucMeekes]

Wait for Prime 3.2 at least. See:

How can I input long expressions which need to go into multiple lines?

Success!
Luc

[JeffH1]

From what I've seen, PTC has this feature planned (for the moment) for release 4.0.  It's actually an improvement over the Mathcad 15 functionality because it doesn't have to be a + operator at the break.

For now, however, it can't be done in Prime 3.0/3.1.  You can, however, shrink the font size on the equation if you need just a little more room.

Jeff

[MikeArmstrong]

Jeff Henning wrote:

From what I've seen, PTC has this feature planned (for the moment) for release 4.0.  It's actually an improvement over the Mathcad 15 functionality because it doesn't have to be a + operator at the break.

For now, however, it can't be done in Prime 3.0/3.1.  You can, however, shrink the font size on the equation if you need just a little more room.

Jeff

Are they planning on adding just the - operator or others?

Mike

[RichardJ]

At least +, -, *. I think that's all, but perhaps also inline division

[MikeArmstrong]

Richard Jackson wrote:

At least +, -, *. I think that's all, but perhaps also inline division

Well that will have to go down as an improvement then