cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Creating New Balloons for Assembly Drawing

gvalley
6-Contributor

Creating New Balloons for Assembly Drawing

After creating a new assembly drawing along with a bill of materials list, we hit "Create Balloons - All". It seemed to have missed some of the parts and not give them a balloon at all, just skipping over them. We tried "Create Balloons - By Component" to add them to parts that were lacking but ran into trouble when it just wouldn't label the components after clicking them, double clicking, middle clicking. How do we go about adding our own balloons to correspond with the bill of materials list?

Garrett Valley

FRC 4931 Student

1 ACCEPTED SOLUTION

Accepted Solutions
smorris
5-Regular Member
(To:gvalley)

Best thing to double check is what level of the assembly these parts exist at. Depending on the filters and recursive settings, you might not be including them. If the item is showing up in your BOM table, you should definitely have a balloon for it.

View solution in original post

1 REPLY 1
smorris
5-Regular Member
(To:gvalley)

Best thing to double check is what level of the assembly these parts exist at. Depending on the filters and recursive settings, you might not be including them. If the item is showing up in your BOM table, you should definitely have a balloon for it.

Top Tags