Start a topic
With the exception of Windchill, The PTC Community is on read-only status until April 6 in preparation for moving our community to a new platform. Learn more here
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

The PTC Community is on temporary read only status in preparation for moving our community to a new platform. Learn more here

Translate the entire conversation x

Generative design fails to reconstruct shapes in Creo 8.0.0

VD_6920028
2-Explorer
2-Explorer
‎Jul 05, 2024 09:05 AM
‎Jul 05, 2024 09:05 AM

Generative design fails to reconstruct shapes in Creo 8.0.0

Hello all,

I have used generative design in order to make lighter my design. But when I generated results, the reconstructed shapes had an issue, the Align command for two different curves was not created. I have tried to create manually alignment, but it is not accept it.

Thanks in advance for your help!

Best regards,
Vlas

Align problem.png

Labels:
0 Kudos
Notify Moderator
1 REPLY 1
ProFeature
16-Pearl
16-Pearl
(To:VD_6920028)
‎Jul 05, 2024 09:34 AM
‎Jul 05, 2024 09:34 AM

HI @VD_6920028 

Have you tried increasing the part accuracy?

Notify Moderator
Announcements


NEW Creo+ Topics: Real-time Collaboration

Contact Community Management
Top Tags