Hi, I am trying to model a piece of tubing that is .160 OD and .110 ID. It is packaged by wraping four times around your four fingers and allowing the two ends to extend down 1" past the bottom of the loop.I am attaching PDF of my attempt.Please advise. Thank You
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
