Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Hello,
I would like to create a snap line in drawing file. offset Value of this snap line should be governed by parameter value. Is it possible?
Thanks and Regards
Ketan
No, it is not possible.
MH
Hi,
Is there any other way to do so? I need to move dimension based on master model for different values.
Thanks and Regards
Ketan
Hi,
Thanks for your time. I am trying to understand what you have done. Could you please share details in English?
Thanks and Regards
Ketan
You can create this wire in the 3 d model, can get the projection lines in engineering drawing.
Operating as follows:
Good thought.
Sorry, my English is poor.
no problem. Appreciate your help on this.........
You're welcome