Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily.
X
Fellows,I'm trying to create new object attribute in Intralink, however I get the following error message:"Can not change to ReadOnly mode because there are other transactions still in progress"Please note that when trying to delete exist object attribute there is no problem.
I'll throw a longshot out there. a few times I accidentally tried to purge, and didnt specify a folder so it was just hanging. I had to kill the client, which left the purge suspended. Anyway, if I did that if left everything locked. I had to run this: <dataserver_loadpoint>/intralink/diag/job_ctrl stop dschangeme <dataserver_loadpoint>/intralink/diag/job_ctrl start dschangeme see tpi 34500. This is not your same situation but may be a clue. maybe search on job_ctrl command. Mark Steffke